Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL SAFE OPERATION
  1. If there is a problem with sensor signals or actuator systems, the skid control ECU prohibits power supply to the brake actuator and informs the ECM of VSC system failure.
    The brake actuator turns off each solenoid and the ECM shuts off VSC control (traction control signal) from the skid control ECU accordingly, which turns out to be as if the ABS, TRAC and VSC systems were not installed.
    The ABS control will be prohibited, but EBD control continues as much as possible. If EBD control is impossible, the BRAKE warning light comes on to warn the driver (Click here).
  2. If system components have any malfunction before starting control, immediately stop the operation.
    If system components have any malfunction during control, gradually stop the control so as not to trigger a sudden change in vehicle conditions.
    If it is impossible to control the systems, the warning light comes on to inform the driver of termination of the systems (Click here).

HINT:
If the hydraulic brake booster encounters a malfunction, brake performance is gradually lost and ABS, BA, TRAC, A-TRAC, VSC, AUTO LSD, DAC and HAC system control is prohibited.

  1. ABS, EBD and BA system:

    HINT:
    A malfunction in either the ABS or BA system will result in an identical operation, with ABS, BA, TRAC, A-TRAC, VSC, AUTO LSD, DAC and HAC system control prohibited.


    Malfunction Area
    Control Method
    ABS system
    ABS, BA, TRAC, A-TRAC, VSC, AUTO LSD, DAC and HAC control is prohibited
    BA system
    ABS, BA, TRAC, A-TRAC, VSC, AUTO LSD, DAC and HAC control is prohibited
    EBD system
    ABS, EBD, BA, TRAC, A-TRAC, VSC, AUTO LSD, DAC and HAC control is prohibited

  2. TRAC, A-TRAC, VSC, AUTO LSD, DAC and HAC system:

    HINT:
    As for the TRAC, A-TRAC, VSC, AUTO LSD, DAC and HAC systems, different systems prohibit different controls according to a malfunctioning part.


    Malfunction Area
    Control Method
    Engine control system
    (TRAC, A-TRAC and VSC systems)
    Before control: Disables control
    During control: Uses only brakes to effect control
    Brake control system
    (VSC system)
    Before control: Disables control
    During control: Uses only engine to effect control
    Brake control system
    (TRAC, A-TRAC, AUTO LSD, DAC and HAC system)
    Brake control: Disables control
    During control: Disables control (by gradually ending control)


SYSTEM TEMPERATURE PROTECTION OPERATION
If the TRAC, A-TRAC, AUTO LSD, DAC, or HAC system has been used constantly for a long time, the temperature of the brake actuator, built in the hydraulic brake booster, may excessively increase. If the temperature excessively increases, the skid control buzzer will sound intermittently. If the temperature increases more, the skid control buzzer sounds for 3 seconds and the indicator light either comes on or blinks.

System
Indicator Condition
TRAC, A-TRAC, AUTO LSD and HAC systems
SLIP indicator light comes on
DAC system
SLIP indicator light comes on
DAC indicator light blinks

HINT:
  1. If the SLIP indicator light goes off (as for the DAC system, the DAC indicator light also comes on), the systems automatically return to normal operating conditions.
  2. As this is not a malfunction, no DTC will be recorded.