Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS


    I042827E01
  1. If the skid control ECU detects a malfunction, the ABS, BRAKE, VSC TRAC warning lights and the VSC OFF, SLIP, DAC indicator lights will come on to warn the driver.
    The table below indicates which lights will come on when there is a malfunction in a particular function.


Item / Trouble Area
ABS
EBD
BA
VSC
TRAC
A-TRAC
(4WD)
AUTO LSD
DAC
(4WD)
HAC
ABS Warning Light
○
○
○
-
-
-
-
-
-
BRAKE Warning Light
-
○
-
-
-
-
-
-
-
VSC TARC Warning Light
○
○
○
○
○
○
○
○
○
VSC OFF Indicator Light (4WD)
○
○
○
○
○
○
○
○
○
SLIP Indicator Light
○
○
○
○
○
○
○
○
○
AUTO LSD Indicator Light
-
-
-
-
-
-
-
-
-
DAC Indicator Light (4WD)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
○: Light ON ●: Light ON (Blinking) -: Light OFF
  1. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the SST between terminals TC and CG of the DLC3 and observing the blinking of the ABS and VSC TRAC warning lights, or by connecting the intelligent tester.
  2. This system has a signal check function (test mode). The DTC can be read by connecting the intelligent tester and observing the blinking of the ABS and VSC TRAC warning lights.

WARNING LIGHT AND INDICATOR LIGHT BULB CHECK


    I042827E01
  1. Release the parking brake lever.

    NOTICE:
    When releasing the parking brake, set the chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

  2. When the ignition switch is turned to the ON position, check that the ABS, BRAKE, and VSC TRAC warning lights and the VSC OFF, SLIP, AUTO LSD, and DAC indicator lights come on for approximately 3 seconds.

    HINT:
    If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS, BRAKE, and VSC TRAC warning light circuits, and the VSC OFF, SLIP, AUTO LSD, and DAC indicator light circuits.
    If the indicator remains on, proceed to troubleshooting for the light circuit below.
    Trouble area
    See procedure
    ABS warning light circuit
    Click here
    BRAKE warning light circuit
    Click here
    VSC TRAC warning light circuit
    Click here
    VSC OFF indicator light circuit
    Click here
    SLIP indicator light circuit
    Click here
    AUTO LSD indicator light circuit
    Click here
    DAC indicator light circuit
    Click here