Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1203/53    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The circuit is used to send TRAC and VSC control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU via the CAN communication system.

DTC No.
DTC Detection Condition
Trouble Area
C1203/53
Engine drive source and destination variation that are sent from the ECM do not match the one of the ECU.
ECM

WIRING DIAGRAM


C132914E01


INSPECTION PROCEDURE

1.CHECK DTC (FOR ENGINE CONTROL SYSTEM)
  1. Check if the engine control system DTC is output (Click here for 1GR-FE, or Click here for 2UZ-FE).

    Result:

    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT ENGINE CONTROL SYSTEM
A

REPLACE ECM