Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by blinking the ABS and VSC TRAC warning lights.

WIRING DIAGRAM


C114570E05

HINT:
When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.INSPECT DLC3 (DLC3 (TC) - DLC3 (CG))


    F100115E45
  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    D1-13 (TC) - D1-4 (CG)
    10 to 14 V



NG
Go to step 4
OK


2.CHECK DTC (FOR CAN COMMUNICATION SYSTEM)
  1. Check for CAN communication system DTC.

    Result:

    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


3.CHECK ECM (DLC3 (TC) INPUT)


    F100115E45
  1. Using SST, connect terminal TC and CG of the DLC3.

SST
09843-18040  
  1. Check if the engine warning light is blinking.

    OK:
    Engine warning light is blinking.



NG
REPLACE ECM
OK

REPLACE MASTER CYLINDER SOLENOID 

4.CHECK HARNESS AND CONNECTOR (ECM - DLC3 (TC))


    C140803E04
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E8-23 (TC) - D1-13 (TC)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (DLC3 (CG) - BODY GROUND)


    F100115E46
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    D1-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.CHECK ECM (DLC3 (TC) INPUT)


    F100115E45
  1. Using SST, connect terminals TC and CG of the DLC3.

  1. Check if the engine warning light is blinking.


Result:

Condition
Proceed to
Engine warning light is blinking
A
Engine warning light is not blinking
B



B
REPAIR OR REPLACE WIRE HARNESS OR ECM (TC AND/OR ECM CIRCUIT)
A


7.CHECK DTC (FOR CAN COMMUNICATION SYSTEM)
  1. Check for CAN communication system DTC.

    Result:

    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A

REPLACE MASTER CYLINDER SOLENOID