Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The BRAKE warning light comes on when brake fluid is insufficient, the parking brake is applied or the EBD is defective.

WIRING DIAGRAM


C132927E02


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.INSPECT BRAKE WARNING LIGHT
  1. Disconnect the skid control ECU (S29) connector.

  1. Turn the ignition switch to the ON position.

  1. Check that the BRAKE warning light comes on.

    OK:
    BRAKE warning light comes on.



OK
REPLACE MASTER CYLINDER SOLENOID
NG


2.INSPECT BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


3.INSPECT GAUGE FUSE
  1. Remove the GAUGE fuse from the driver side J/B.

  1. Check the GAUGE fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE GAUGE FUSE
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    I045767E03
  1. Install the GAUGE fuse.

  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S29-3 (BRL) - C11-2
    Below 1 Ω
    S29-3 (BRL) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT COMBINATION METER ASSEMBLY
  1. Reconnect the skid control ECU (S29) connector and combination meter connector.

  1. Check if the indicators (shift position, airbag etc.) other than BRAKE warning light operate normally.

    Result:

    Condition
    Proceed to
    Indicators OK
    A
    Indicators NG
    B



B
GO TO COMBINATION METER SYSTEM
A

REPLACE COMBINATION METER ASSEMBLY