Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > VSC TRAC Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

If the skid control ECU stores DTCs to shut down VSC and TRAC operation, the VSC TRAC warning light comes on in the combination meter.

WIRING DIAGRAM


C132926E03


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.INSPECT VSC TRAC WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Ground terminal VSCW of the skid control ECU.

  1. Turn the ignition switch to the ON position.

  1. Check that the VSC TRAC warning light comes on.

    OK:
    VSC TRAC warning light comes on.



OK
REPLACE MASTER CYLINDER SOLENOID
NG


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    I045338E16
  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-36 (VSCW) - C10-18
    Below 1 Ω
    S28-36 (VSCW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

END