Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

When the center differential is locked, VSC control turns off and the VSC OFF indicator illuminates.

WIRING DIAGRAM


C132928E02


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.INSPECT VSC OFF INDICATOR LIGHT
  1. Disconnect the skid control ECU connector.

  1. Ground terminal WT of the skid control ECU.

  1. Turn the ignition switch to the ON position.

  1. Check that the VSC OFF indicator light comes on.

    OK:
    VSC OFF indicator light comes on.



OK
REPLACE MASTER CYLINDER SOLENOID
NG


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    I045338E18
  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-35 (WT) - C10-17
    Below 1 Ω
    S28-35 (WT) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

END