Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1761/61    ECU Malfunction

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detecting Condition
Trouble Area
C1761/61
Suspension control ECU malfunction
Suspension control ECU

INSPECTION PROCEDURE

HINT:
  1. If DTC C1774/74 (power source circuit) is displayed, perform the inspection necessary for DTC C1774/74 first (Click here).
  2. If DTC C1713/13 (right rear height control sensor circuit), C1714/14 (left rear height control sensor circuit) and C1761/61 (ECU malfunction) are output at the same time, perform the inspection necessary for DTC C1761/61 first.

1.INSPECT HEIGHT CONTROL OFF INDICATOR LIGHT
  1. Turn the ignition switch to ON, and check the height control OFF indicator light.

    Result:
    A:
    Height control OFF indicator light come on
    B:
    Height control OFF indicator light does not come on



B
REPLACE SUSPENSION CONTROL ECU
A


2.INSPECT SUSPENSION CONTROL ECU (HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR POWER SOURCE)


    F043242E01
  1. Remove the suspension control ECU with connectors being connected.

  1. Turn the ignition switch ON, and measure voltage between terminals S13-20 (SBR2) and S15-1 (GND) and between terminals S13-22 (SBL2) and S15-1 (GND) of the suspension control ECU connector.

    Standard voltage:
    4.5 to 5.5 V



NG
CHECK HEIGHT CONTROL SENSOR SUB-ASSEMBLY CIRCUIT
OK


3.INSPECT SUSPENSION CONTROL ECU (ECU POWER SOURCE)


    F043242E02
  1. Turn the ignition switch OFF, and measure voltage between terminals S14-6 (B) and S15-1 (GND) and between S14-6 (B) and S14-5 (GND2) of the suspension control ECU connector.

    Standard voltage:
    10 to 14 V



NG
CHECK POWER SOURCE CIRCUIT
OK

REPLACE SUSPENSION CONTROL ECU