Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

AIR SUSPENSION SYSTEM > Height Control OFF Indicator Light Circuit

for Preparation Click here


DESCRIPTION

If the suspension control ECU detects a problem, the height control OFF indicator light comes on while suspending the height control function at the same time. At the same time, the suspension control ECU records a DTC in the memory.
Connect terminals TC and CG of the DLC3 to make the height control manual indicator light blink and output DTCs.

WIRING DIAGRAM


F050634E01


INSPECTION PROCEDURE

1.INSPECT HEIGHT CONTROL OFF INDICATOR LIGHT
  1. Turn the ignition switch to the ON position.

  1. Check that the height control manual indicator light comes on.

    OK:
    Height control manual indicator light comes on, and then goes off after 2 seconds.



NG
GO TO COMBINATION METER SYSTEM
OK


2.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - COMBINATION METER)
  1. Check for open and short circuit in the harness and the connector between the suspension control ECU and the combination meter (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU 

3.CHECK CONNECTORS
  1. Check that the connectors are properly connected to the suspension control ECU.

    OK:
    The connectors are properly connected.



NG
CONNECT CONNECTORS
OK


4.CHECK DTC
  1. Clear and check the DTC (Click here).

    Result:
    Result
    Proceed to
    Normal system code is output.
    A
    DTC is output.
    B



NG
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
OK


5.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - COMBINATION METER)
  1. Check for open and short circuit in the harness and the connector between the suspension control ECU and the combination meter (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU