Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

AIR SUSPENSION SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC (USING SST CHECK WIRE)


    F100115E02
  1. Checking DTCs using the SST check wire.

    SST
    09843-18040  

    1. Using the SST, connect terminals TC and CG of the DLC3.

    2. Turn the ignition switch to the ON position.



    3. F041674
    4. Read and record any DTCs from the height control OFF indicator light on the combination meter.



    5. C123990E01
    6. As examples, the blinking patterns of a normal system code and codes 13 and 33 are shown in the illustration.

      HINT:
      1. If the height control OFF indicator light does not blink any DTC or a normal system code, inspect the height control OFF indicator light circuit (Click here) and the TC terminal circuit (Click here).
      2. If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.

    7. Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.

    8. After completing the check, remove the SST check wire from the DLC3.

      SST
      09843-18040  



  2. F100115E02
  3. Clearing the DTCs using the SST check wire.

    SST
    09843-18040  

    1. Using SST, connect terminals TC and CG of the DLC3.

    2. Turn the ignition switch to the ON position.



    3. F042949
    4. Clear DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    5. Check that the height control OFF indicator light shows a normal system code.

    6. Remove the SST check wire from the DLC3.

      SST
      09843-18040  

      HINT:
      Disconnecting the battery cable during the operation will not erase DTCs in the ECU.


CHECK DTC (USING INTELLIGENT TESTER)
A066288E03
  1. Checking DTCs using the intelligent tester.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Read DTCs by following the prompts on the tester screen.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

  2. Clearing the DTCs using the intelligent tester.

    1. Connect the intelligent tester to the DLC3

    2. Turn the ignition switch to the ON position.

    3. Erase the DTCs following the prompts on the tester screen.

      HINT:
      Refer to the intelligent tester operator's manual for further details.