BRAKE FLUID > BLEEDING |
| 1. FILL RESERVOIR WITH BRAKE FLUID |
| 2. BLEED BRAKE BOOSTER W/ACCUMULATOR PUMP ASSEMBLY |
Turn the ignition switch off, depress the brake pedal 20 times or more, and release the pressure from the accumulator.
Fully depress the brake pedal 10 times.
Turn the ignition switch to the ON position and start the brake booster pump.
Make sure the pump operates for 8 to 14 seconds.
If the pump does not operate as specified, repeat steps (a) to (c) and recheck the operating time.
| 3. BLEED BRAKE LINE |
![]() |
Front brake line
Turn the ignition switch to the ON position and wait until the pump motor has stopped.
Connect the vinyl tube to the brake caliper.
Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down.
At the point when the fluid stops coming out, tighten the bleeder plug, then release the brake pedal.
Repeat (3) and (4) until all the air in the fluid has been bled out.
Repeat the above procedures to bleed the other brake line.
![]() |
Rear brake line
Turn the ignition switch to the ON position and depress the brake pedal.
Connect the vinyl tube to the brake caliper.
Loosen the bleeder plug and release air.
When the air is completely bled out of the brake fluid through the bleeder plug, tighten the bleeder plug.
Repeat the above procedures to bleed the other brake line.
| 4. BLEED MASTER CYLINDER SOLENOID |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Select "ACTIVE TEST" mode on the intelligent tester.
Connect the vinyl tube to the rear brake caliper.
Loosen the bleeder plug.
Select "SRMF & SRMR" to drive the solenoids and bleed air from the rear brake caliper.
Repeat step (f) until all the air in the brake fluid is bled out.
When the air is completely bled out of the brake fluid through the bleeder plug, tighten the bleeder plug.
Repeat the above procedures to bleed the other brake line.
Turn the ignition switch off.
Turn the ignition switch to the ON position.
Clear DTC (Click here).
| 5. CHECK FLUID LEVEL IN RESERVOIR |