VEHICLE STABILITY CONTROL SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK / CLEAR (SST CHECK WIRE) |
![]() |
DTC check
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to the ON position.
Read the DTCs from the ABS and VSC TRAC warning lights on the combination meter.
| Trouble Area | See procedure |
| TC and CG terminal circuit |
Click here
|
| ABS warning light circuit |
Click here or Click here
|
| VSC TRAC warning light circuit |
Click here or Click here
|

Codes are explained in the code table (Click here).
After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display.
If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.
DTC clear
![]() |
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to the ON position.
![]() |
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
check that the warning light indicates the normal system code.
Remove the SST from the terminals of the DLC3.
| DTC CHECK / CLEAR (INTELLIGENT TESTER) |
DTC check
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Read the DTCs following the prompts on the tester screen.
DTC clear
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Operate the intelligent tester to clear the codes.
| END OF DTC CHECK / CLEAR |
Turn the ignition switch to the ON position
Check that the ABS and VSC TRAC warning lights go off within approximately 3 seconds.