Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > INSTALLATION

for Preparation Click here



1. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH


    F043121
  1. Install the disc brake cylinder assembly with 2 bolts.

    Torque:
    123 N*m{ 1,254 kgf*cm , 91 ft.*lbf }



    F043120
  1. Using SST, connect the brake tube to the disc brake cylinder assembly.

    SST
    09023-00101  

    Torque:
    15.2 N*m{ 155 kgf*cm , 11 ft.*lbf }



2. INSTALL ANTI SQUEAL SHIM KIT FRONT

NOTICE:
If necessary, replace the anti-squeal shim kit when replacing the brake pad.

  1. Install the anti-squeal shims on each brake pads.

    NOTICE:
    There should be no oil or grease on the friction surfaces of the brake pads and the front disc.



3. INSTALL DISC BRAKE PAD KIT FRONT (PAD ONLY)
  1. Install the 2 disc brake pads with anti-squeal shim to the disc brake cylinder assembly.



4. INSTALL FRONT DISC BRAKE ANTIRATTLE W/HOLE PIN
  1. Install the 2 anti-rattle w/ hole pins and anti-rattle spring to the disc brake cylinder.

    HINT:
    Anti-rattle spring is installed with bottom side of anti-rattle w/ hole pin.

  1. Install the 2 new pin hole clips to the anti-rattle w/ hole pin.

    NOTICE:
    When installing the pin hole clip, be sure to install the pin hole clip with the handle facing to the vehicle center.



5. FILL RESERVOIR WITH BRAKE FLUID


6. BLEED BRAKE LINE

HINT:
(Click here)



7. CHECK FLUID LEVEL IN RESERVOIR


8. CHECK BRAKE FLUID LEAKAGE


9. INSTALL FRONT WHEEL

Torque:
110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }