Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > INSTALLATION

for Preparation Click here



1. INSTALL REAR DISC BRAKE CYLINDER SLIDE BUSH
  1. Apply the lithium soap base glycol grease to a new cylinder hole plug and 2 new cylinder slide bushes.

  1. Install the cylinder hole plug and 2 cylinder slide bush to the rear disc brake cylinder mounting.



2. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH


    F043126
  1. Install the rear disc brake cylinder mounting with 2 bolts.

    Torque:
    105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }



3. INSTALL REAR DISC BRAKE PAD SUPPORT PLATE
  1. Install the 4 pad support plates on the rear disc brake cylinder mounting.



4. INSTALL REAR DISC BRAKE PAD WEAR INDICATOR PLATE
  1. Install the pad wear indicator plate on the inner side disc brake pad.

    HINT:
    Install the pad wear indicator facing downward.



5. INSTALL REAR DISC BRAKE ANTI-SQUEL SHIM

NOTICE:
If necessary, replace the anti-squeal shim kit when replacing the brake pad.

  1. Install the anti-squeal shims on each brake pad.

    NOTICE:
    There should be no oil or grease on the friction surfaces of the brake pads and the rear disc.



6. INSTALL DISC BRAKE PAD KIT REAR (PAD ONLY)
  1. Install the 2 disc brake pads with anti-squeal shim to the disc brake cylinder assembly.



7. INSTALL DISC BRAKE CYLINDER ASSEMBLY REAR LH


    F043124
  1. Apply the lithium soap base glycol grease to the sliding part of 2 cylinder slide pins.

  1. Install the disc brake cylinder assembly rear with 2 cylinder slide pins.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



8. CONNECT REAR LH FLEXIBLE HOSE


    F043125
  1. Connect the flexible hose with union bolt and new gasket to the disc brake cylinder assembly rear.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }



9. FILL RESERVOIR WITH BRAKE FLUID


10. BLEED BRAKE LINE

HINT:
(Click here)



11. CHECK FLUID LEVEL IN RESERVOIR


12. CHECK BRAKE FLUID LEAKAGE


13. INSTALL REAR WHEEL

Torque:
110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }