ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK |
| |||||
| 3.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output.
Delete the DTC.
Recheck for DTCs. Try to prompt the DTC (SFI system and engine immobiliser system) by simulating the original activity that the DTC suggested.
If the DTC does not reoccur, proceed to A.
If the DTC (SFI system) reoccurs, proceed to B.
If the DTC (engine immobiliser system) reoccurs, proceed to C.
|
| ||||
|
| ||||
| |||||
| 5.READ VALUE OF INTELLIGENT TESTER ((IMMOBILISER ECU (TRANSPONDER KEY ECU ASSEMBLY) (SWITCH CONDITION)) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and push the intelligent tester main switch ON.
Select the item KEY SW in the DATA LIST and read its value displayed on the intelligent tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| KEY SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
If the fault is not listed on the problem symptoms table, proceed to A.
If the fault is listed on the problem symptoms table, proceed to B.
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
Inspection with the intelligent tester (DATA LIST).
Inspection with the intelligent tester (ACTIVE TEST).
Terminals of ECU (Click here).
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|