DTC P2610 ECM / PCM Internal Engine Off Timer Performance |
| DTC | Monitoring Items | Malfunction Detection Conditions | Trouble Areas | Detection Timings | Detection Logic |
| P2610 | Soak timer (built into ECM) | ECM internal malfunction | ECM | Engine running | 2 trip |

| Related DTCs | P2610: Soak timer (bulit into ECM) |
| Required sensors / components | ECM |
| Frequency of operation | Once per driving cycles |
| Duration | 10 minutes |
| MIL operation | 2 driving cycles |
| Sequence operation | None |
| The monitor will run whenever these DTCs are not present | None |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Engine | Running |
| Soak timer measurement when ECM CPU clock counts 10 minutes | Less than 7 minutes or more than 13 minutes |
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Clear DTCs (Click here).
Start the engine and wait for 10 minutes or more.
Select the following menu items on the tester: DIAGNOSIS / ENHANCED OBD II / DTC INFO / PENDING CODES.
If no pending DTC is displayed, the repair has been successfully completed.
|
| ||||
| OK | ||
| ||