CAN COMMUNICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.CHECK AND CLEAR DTCs |
| |||||
| 2.CHECK CAN BUS LINE |
| |||||
| 3.CHECK USING INTELLIGENT TESTER VIA CAN VIM |
Select the "BUS CHECK" (Click here).
| Proceed to | Result |
| A | All ECUs and sensors connected to the CAN communication system are displayed. |
| B | An ECU or sensor not connected to the CAN communication system is displayed. |
| C | A few ECUs or sensors not connected to the CAN communication system are displayed. |
|
| ||||
|
| ||||
| |||||
| 4.CHECK DTC COMBINATION TABLE |
Confirm trouble according to the combination of output DTCs regarding the CAN communication system.
| |||||
| 5.CIRCUIT INSPECTION |
| |||||
| 6.IDENTIFICATION OF PROBLEM |
| |||||
| 7.REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|