Home › ENGINE ยท 1GR-FE › FUEL › FUEL SYSTEM

FUEL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FUEL PUMP OPERATION AND FUEL LEAK
  1. When using the intelligent tester

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON and intelligent tester main switch ON.

      NOTICE:
      Do not start the engine.

    3. Select the ACTIVE TEST mode on the intelligent tester.

    4. Please refer to the intelligent tester operator's manual for further details.



    A067117E01
  1. When not using the intelligent tester

    1. Remove the circuit opening relay.

    2. Using a service wire, connect terminals FP and +B of the relay block.

      NOTICE:
      Pay due attention to the terminal connecting position to avoid a malfunction.

    3. Turn the ignition switch ON, and check that the fuel pump operates.

      NOTICE:
      Do not start the engine.

  1. Check that there are no fuel leaks after doing maintenance to the fuel system.

  1. Turn the ignition switch OFF.

  1. Disconnect the intelligent tester from the DLC3.



2. CHECK FUEL PRESSURE


    A062159E01
  1. Prepare for inspection.

    1. Prepare a new fuel tube, and take out the fuel tube connector from the tube.

      HINT:
      Part No. 23801-31070

  1. Prevent gasoline from spilling out (Click here).

  1. Disconnect the EFI fuel pipe clamp (Click here).

  1. Disconnect the fuel pipe No. 1 from the fuel main tube.



    A065093E01
  1. Install SST (pressure gauge) as shown in the illustration by using the SSTs and a fuel tube connector.

    SST
    09268-31011   (90467-13001, 95336-08070)
    09268-45014   (09268-41200, 09268-41220, 09268-41250, 90467-13001)

  1. Wipe off any splattered gasoline.

  1. Start the engine.

  1. Measure the fuel pressure at idle.

    Fuel pressure:
    281 - 287 kPa (2.87 - 2.93 kgf/cm2, 40.8 - 41.7 psi)

  1. Stop the engine.

  1. Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.

    Fuel pressure:
    147 kPa (1.5 kgf/cm2, 21 psi) or more

    If pressure is not as specified, check the fuel pump, pressure regulator and/or injectors.

  1. After checking the fuel pressure, disconnect the negative (-) terminal cable from the battery carefully, remove the SST and fuel tube connector to prevent gasoline from the splashing.

  1. Reconnect the fuel tube to the fuel main tube.

  1. Install the EFI fuel pipe clamp.

  1. Check for fuel leak.