Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY (for Rear No. 1 Seat)

REAR SEAT OUTER BELT ASSEMBLY (for Rear No. 1 Seat) > REMOVAL

for Preparation Click here


HINT:
Use the same procedures for the LH and RH.



1. REMOVE TONNEAU COVER RETRACTOR SUB-ASSEMBLY


2. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (with Rear No. 2 Seat)


3. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (with Rear No. 2 Seat)


4. REMOVE NO.2 SEAT LEG COVER (with Rear No. 2 Seat)


5. REMOVE REAR NO. 2 SEAT LOCK ASSEMBLY RH (with Rear No. 2 Seat)
  1. Remove the 2 bolts and seat lock.



6. REMOVE BACK DOOR GLASS WEATHERSTRIP


7. REMOVE DECK BOARD SUB-ASSEMBLY (without Rear No. 2 Seat)
  1. Remove the 2 bolts and the deck board sub-assembly.



8. REMOVE DECK BOARD ASSEMBLY (without Rear No. 2 Seat)

HINT:
Click here



9. REMOVE REAR FLOOR MAT SUPPORT PLATE REAR

HINT:
Click here



10. REMOVE DECK FLOOR BOX RH
  1. Remove the bolt, deck floor box and luggage hold belt striker.



11. REMOVE DECK TRIM COVER REAR
  1. Using a screwdriver, pry out the trim cover.

    HINT:
    Tape the screwdriver tip before use.



12. REMOVE DECK TRIM SIDE BOARD UPR RH
  1. Remove the screw and side board.



13. REMOVE SIDE TRIM BOX ASSEMBLY RH
  1. Remove the screw and side trim box.



14. REMOVE QUARTER SCUFF PLATE INNER RH (with Rear No. 2 Seat)


15. REMOVE REAR DOOR SCUFF PLATE RH


16. REMOVE REAR DOOR WEATHERSTRIP RH


17. REMOVE DECK TRIM COVER REAR


18. REMOVE REAR FLOOR CARPET ASSEMBLY


19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
  1. Remove the floor anchor cover.

  1. Remove the bolt and seat belt assembly outer on the floor anchor side.

  1. Remove the side panel assembly .



20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (with Rear No. 2 Seat)
  1. Remove the floor anchor cover.

  1. Remove the bolt and No. 2 seat belt outer RH on the floor anchor side.

  1. Remove the side panel.



21. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER RH


22. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER RH (with Rear No. 2 Seat)
  1. Remove the bolt and No. 2 seat belt outer RH on the shoulder anchor side.

  1. Remove the side garnish.



23. REMOVE 3 POINT TYPE BELT ASSEMBLY RH (for Rear No. 1 Seat)
  1. Remove the 2 bolts on the retractor side, and thoroughly remove the seat belt.