Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING VALVE AND TRANSMITTER

TIRE PRESSURE WARNING VALVE AND TRANSMITTER > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER


    F046445E02
  1. Insert the tire pressure monitor valve into the valve installation hole. Insert from the inside of the rim so that the print surface can be seen.

    NOTICE:
    1. Check that there is no visible deformation, damage or other abnormalities on the transmitter.
    2. Check that there is no foreign matter on the inner grommet and around the rim hole.
    3. If installed in the reverse direction, the tire pressure monitor valve may be damaged or fail to transmit signals when running at high speed.



    F046446E03
  1. Install the washer on the tire pressure monitor valve from the rim side and tighten with a nut.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

    NOTICE:
    1. Check that there is no foreign matter on the washer and nut.
    2. When removing the tire pressure monitor valve if the tire is removed for replacement, check that there is no damage or cuts, and no foreign matter such as mud, dirt or sand attached to the grommet. Replace the grommet with a new one if any of the defects mentioned above are found.
    3. Check that there is no oil, water or lubricant around the rim hole, tire pressure monitor valve, washer and nut. Failing to do so may result in improper installation.

  1. After the tire is inflated, the valve nut may be loose. Retighten the nut to the specified torque and then check for air leaks with soapy water.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



    F046447E05
  1. Set the wheel disc to the mounting machine and install the lower tire bead. At the time, position the main body of the sensor to the shaded area shown in the illustration.

    NOTICE:
    If the sensor is positioned outside this area, it generates interference with the tire bead, causing possible damage to the sensor.

  1. Install the upper bead.

    NOTICE:
    Make sure that the tire bead and tool do not interfere with the main body of the sensor and that the sensor is not clamped by the bead.



2. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



3. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. INSPECT TIRE


5. REGISTRATION OF TRANSMITTER ID

HINT:
(Click here)



6. INSPECT TIRE PRESSURE WARNING SYSTEM

HINT:
(Click here)