Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > REGISTRATION

for Preparation Click here



1. REGISTRATION OF TRANSMITTER ID

NOTICE:
It is necessary to register the transmitter ID in the tire pressure monitor ECU when replacing the tire pressure monitor valve sub-assembly and/or tire pressure monitor ECU.

  1. Set the tire pressure of all wheels to the specified value.

    Front
    Rear
    Spare
    220 kPa (2.2 kgf/cm2, 32 psi)
    220 kPa (2.2 kgf/cm2, 32 psi)
    220 kPa (2.2 kgf/cm2, 32 psi)

  1. Connect the intelligent tester to DLC3.

  1. Turn the ignition switch to the ON position.

  1. Read and write down the ID by using the DATA LIST (Procedure "A").

  1. Select the registration mode "MAIN".

  1. Input the ID using the intelligent tester and transmit it to the tire pressure monitor ECU (Procedure "B").



  1. Set the ID transmission condition to "COMPLETE".


    F045858

    HINT:
    If the operation of procedure "A" to "B" does not complete within 5 min., the mode will return to the normal operation mode.



2. CONFIRMATION OF TRANSMITTER ID REGISTRATION
  1. Set the tire pressure of all wheels to the specified value.

    Front
    Rear
    Spare
    220 kPa (2.2 kgf/cm2, 32 psi)
    220 kPa (2.2 kgf/cm2, 32 psi)
    220 kPa (2.2 kgf/cm2, 32 psi)

  1. Connect the intelligent tester to DLC3.

  1. Turn the ignition switch to the ON position.

  1. Select the "SIGNAL CHECK" mode on the intelligent tester (Click here).

  1. Forcibly transmit the transmitter IDs for all wheels.

    HINT:
    1. The transmitter ID can be transmitted by rapidly reducing the tire air pressure.
    2. When rapidly reducing the pressure, loosen the valve core.

  1. Check that test mode DTCs C2181/81, C2182/82, C2183/83, C2184/84 and C2185/85 are all erased.

    HINT:
    If they haven't been erased, reset the tire pressure to the specified value and rotate the tire 90 to 270 degrees. Then forcibly transmit the transmitter IDs of all wheels. If they are still output, register the transmitter IDs.

  1. Set the tire pressure of all wheels to the specified value.