Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2141/41    Transmitter ID1 Error

DTC    C2142/42    Transmitter ID2 Error

DTC    C2143/43    Transmitter ID3 Error

DTC    C2144/44    Transmitter ID4 Error

DTC    C2145/45    Transmitter ID5 Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
C2141/41
C2142/42
C2143/43
C2144/44
C2145/45
If an "ERROR" signal is received 3 times consecutively, the tire pressure monitor valve sub-assembly will be judged as defective and this DTC will be output.
This will happen under the situations where the inflation pressure is out of the specified range 0 to 637.5 kPa (0 to 6.48 kgf/cm2, 0 psi to 92.2 psi), the temperature inside the tire is out of the specified range -40 to 215°C (-40 to 419°F), or an error occurs in the tire pressure monitor valve sub-assembly, etc.
  1. Tire pressure monitor valve sub-assembly
  2. Tire pressure monitor ECU
  3. Tire pressure monitor receiver assembly

HINT:
It is necessary to perform the procedure to identify the tire pressure monitor valve sub-assembly that is malfunctioning because it cannot be identified by the output DTC.


INSPECTION PROCEDURE

HINT:
Set the tire pressure to the specified value.

1.CHECK TIRE PRESSURE WARNING LIGHT
  1. Check the tire pressure warning light.

    Result:

    Proceed to
    Result
    A
    Does not blink
    B
    Comes on and goes off repeatedly at 0.5 second intervals



B
Go to step 5
A


2.IDENTIFY TRANSMITTER CORRESPONDING TO DTC

HINT:
Refer to "Error in Present while Identifying Transmitter" (Click here).


NEXT


3.CLEAR DTC

NEXT


4.CHECK DTC
  1. Check for DTC.

    OK:
    DTC is not output

    HINT:
    1. If the result is OK, replace the tire pressure monitor valve sub-assembly specified in STEP 2.
    2. Register the transmitter ID after replacing and then set the tire pressure to the specified value.



NG
Go to step 9
OK

REPLACE TIRE PRESSURE WARNING RECEIVER 

Go to step 9

5.IDENTIFY TRANSMITTER CORRESPONDING TO DTC

HINT:
Refer to "Error in Present while Identifying Transmitter" (Click here).


NEXT


6.REPLACE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
  1. Replace the identified tire pressure monitor valve sub-assembly with a new one.


NEXT


7.REGISTRATION OF TRANSMITTER ID
  1. Register the transmitter ID for all wheels (Click here).

  1. Set tire air pressure to the specified value.


NEXT


8.CHECK DTC
  1. Check for DTC.

    OK:
    DTC is not output.



NG
Go to step 9
OK

END 

9.REPLACE TIRE PRESSURE WARNING RECEIVER

HINT:
Perform the inspection using parts from a normal vehicle when possible.


NEXT


10.CHECK DTC
  1. Check for DTC.

    OK:
    DTC is not output.



NG
REPLACE TIRE PRESSURE WARNING ECU
OK

END