Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



DTC CHECK (USING SST CHECK WIRE)


    F040034E33
  1. Check DTCs.

    1. Using the SST, connect terminals TC and CG of DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.



    3. F045853E02
    4. Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration on the left for examples of a normal system code and codes 13 and 33.

      HINT:
      1. If the tire pressure warning light does not blink any DTCs or the normal system code, inspect the tire pressure warning light circuit or TC terminal circuit.
        Trouble Area
        See page
        Tire pressure warning light circuit
        Click here
        TC terminal circuit
        Click here
      2. If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.



    5. F050628E01
    6. Refer to the Diagnostic Trouble Code Chart for DTC information (Click here).

    7. After completing the check, turn the ignition switch off and remove the SST from DLC3.

      SST
      09843-18040  


DTC CHECK (USING INTELLIGENT TESTER)


    A066288E03
  1. Check the DTCs.

    1. Connect the intelligent tester to DLC3.

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs following the prompts on the tester screen.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

  2. Clear the DTCs.

    HINT:
    After repairing the malfunctions, clear the DTC.


    1. Connect the intelligent tester to DLC3.

    2. Turn the ignition switch to the ON position.

    3. Erase the DTCs following the prompts on the tester screen.

      HINT:
      Refer to the intelligent tester operator's manual for further details.