Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2165/65    Abnormal Temperature Inside ID1 Tire

DTC    C2166/66    Abnormal Temperature Inside ID2 Tire

DTC    C2167/67    Abnormal Temperature Inside ID3 Tire

DTC    C2168/68    Abnormal Temperature Inside ID4 Tire

DTC    C2169/69    Abnormal Temperature Inside ID5 Tire

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
C2165/65
C2166/66
C2167/67
C2168/68
C2169/69
The temperature inside the tire is out of the specified range -40 to 215°C (-40 to 419°F).
  1. Tire pressure monitor valve sub-assembly
  2. Tire pressure monitor ECU
  3. Tire pressure monitor receiver assembly

HINT:
It is necessary to perform the procedure to identify the tire pressure monitor valve sub-assembly that is malfunctioning because it cannot be identified by the output DTC.


INSPECTION PROCEDURE

HINT:
Set the tire pressure to the specified value.

1.CHECK TIRE PRESSURE WARNING LIGHT
  1. Check the tire pressure warning light.

    Result:

    Proceed to
    Result
    A
    Does not blink
    B
    Comes on and goes off repeatedly at 0.5 second intervals



B
Go to step 7
A


2.IDENTIFY TRANSMITTER CORRESPONDING TO DTC

HINT:
Refer to "Error in Present while Identifying Transmitter" (Click here).


NEXT


3.CHECK TIRES

NEXT


4.CLEAR DTC

NEXT


5.CHECK DTC
  1. Check for DTC.

    OK:
    DTC is not output

    HINT:
    1. If the result is OK, replace the tire pressure monitor valve sub-assembly specified in STEP 2.
    2. Register the transmitter ID after replacing and then set the tire pressure to the specified value.



NG
Go to step 12
OK

REPLACE TIRE PRESSURE WARNING VALVE AND TRANSMITTER 

6.CHECK TIRES

NEXT


Go to step 8

7.IDENTIFY TRANSMITTER CORRESPONDING TO DTC

HINT:
Refer to "Error in Present while Identifying Transmitter" (Click here).


NEXT


Go to step 9

8.REPLACE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
  1. Replace the identified tire pressure monitor valve sub-assembly with a new one.


NEXT


Go to step 10

9.REGISTRATION OF TRANSMITTER ID
  1. Register the transmitter ID for all wheels (Click here).

  1. Set the tire pressure to the specified value.


NEXT


Go to step 11

10.CHECK DTC
  1. Check for DTC.

    OK:
    DTC is not output.



NG
Go to step 12
OK

END 

11.REPLACE TIRE PRESSURE WARNING RECEIVER

HINT:
Perform the inspection using parts from a normal vehicle when possible.


NEXT


12.CHECK DTC
  1. Check for DTC.

    OK:
    DTC is not output.



NG
REPLACE TIRE PRESSURE WARNING ECU
OK

END