Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING RECEIVER


    F046094
  1. Install the receiver assembly with the 2 bolts.

    Torque:
    6.8 N*m{ 69 kgf*cm , 60 in.*lbf }

  1. Connect the connector.



2. INSTALL ROOF HEADLINING ASSEMBLY


3. INSTALL REAR NO. 2 SEAT (for 50/50 Split Seat Type)
  1. Install the headrests.

  1. Install the seat.

  1. Install the seat leg cover.



4. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (for 60/40 Split Seat Type LH Side)
  1. Install the seat with the 3 bolts and nut.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Set the rear seat to the floor.



    B064886E01
  1. Install the rear sat cushion hinge covers No. 2 LH and RH.

  1. Tumble the seat.



    B078863E01
  1. Install the rear seat cushion hinge covers No. 2 LH and RH.

  1. Install the headrest.



5. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (for 60/40 Split Seat Type RH Side)
  1. Install the seat with the 3 bolts and nut.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Set the rear seat to the floor.



    B064886E01
  1. Install the rear seat cushion hinge covers No. 3 LH and RH.

  1. Tumble the seat.



    B078863E01
  1. Install the rear seat cushion hinge covers No. 2 LH and RH.

  1. Install the headrest.



6. CONNECT BATTERY NEGATIVE TERMINAL


7. REGISTRATION OF TRANSMITTER ID

HINT:
(Click here)



8. INSPECT TIRE PRESSURE WARNING SYSTEM

HINT:
(Click here)



9. PERFORM INITIALIZATION