Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL
  1. Disconnect the negative terminal.



2. REMOVE REAR NO. 2 SEAT (for 50/50 Split Seat Type)


    B064892E01
  1. Disengage the claws and remove the seat leg cover.



    B064896
  1. Release the rear seat lock and remove the seat.

  1. Remove the headrests.



3. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for 60/40 Split Seat Type LH Side)
  1. Remove the headrest.

  1. Tumble the seat.



    B078863E01
  1. Disengage the claws and remove the rear seat cushion hinge covers No. 2 LH and RH.

  1. Set the rear seat to the floor.



    B064886E01
  1. Disengage the claws and remove the rear seat cushion hinge covers No .3 LH and RH.

  1. Tumble the seat.

  1. Remove the 3 bolts, nut and seat.



4. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for 60/40 Split Seat Type RH Side)
  1. Remove the headrest.

  1. Tumble the seat.



    B078863E01
  1. Disengage the claws and remove the rear seat cushion hinge covers No. 2 LH and RH.

  1. Set the rear seat to the floor.



    B064886E01
  1. Disengage the claws and remove the rear seat cushion hinge covers No. 3 LH and RH.

  1. Tumble the seat.

  1. Remove the 3 bolts, nut and seat.



5. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the instructions for removal of the roof headlining assembly (Click here).



6. REMOVE TIRE PRESSURE WARNING RECEIVER


    F046094
  1. Disconnect the connector.

  1. Remove the 2 bolts and receiver assembly.