Home › ENGINE ยท 2UZ-FE › IGNITION › IGNITION SYSTEM

IGNITION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT IGNITION COIL ASSEMBLY AND SPARK TEST
  1. Confirm DTCs (Click here).

    NOTICE:
    If any DTCs are indicated, carry out troubleshooting in accordance with the procedures for those DTCs.

  1. Check that a spark occurs.

    1. Remove the ignition coils .

    2. Using a 16 mm (0.63 in.) plug wrench, remove the spark plugs.

    3. Install the spark plugs to each ignition coil, and connect the ignition coil connectors.

    4. Disconnect the 8 injector connectors.

    5. Ground the spark plugs.

    6. Check if a spark occurs while the engine is being cranked.

      NOTICE:
      1. Be sure to ground the spark plugs when checking.
      2. Replace the ignition coil if it is subjected to an impact.
      3. Do not crank the engine for more than 2 seconds.

  1. Using a 16 mm (0.63 in.) plug wrench, install the spark plugs.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Install the ignition coils.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }