AUTOMATIC TRANSMISSION ASSEMBLY (for 1GR-FE) > REMOVAL |
| 1. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY |
| 2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY |
| 3. DISCONNECT OXYGEN SENSOR |
| 4. REMOVE EXHAUST PIPE |
| 5. REMOVE PROPELLER SHAFT ASSEMBLY |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts and 4 washers.
![]() |
Remove the propeller shaft.
Insert SST in the transmission to prevent oil leakage.
| 6. DRAIN AUTOMATIC TRANSMISSION FLUID |
![]() |
Remove the drain plug and gasket, and drain the ATF.
Install a new gasket and the drain plug.
| 7. REMOVE FRONT SUSPENSION MEMBER BRACKET |
![]() |
Remove the 4 bolts and front suspension member bracket.
| 8. REMOVE FRONT SUSPENSION MEMBER BRACKET LH |
Remove the 4 bolts and front suspension member bracket LH.
| 9. DISCONNECT NO.1 OIL COOLER OUTLET TUBE |
Remove the 2 bolts and 2 clamps.

Using SST, disconnect the No. 1 oil cooler outlet tube.
| 10. REMOVE NO.1 OIL COOLER INLET TUBE |
![]() |
Using SST, disconnect the No. 1 oil cooler inlet tube.
| 11. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut and clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
| 12. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Support the transmission with a transmission jack.
| 13. REMOVE NO.3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Remove the 4 nuts, 8 bolts and No. 3 frame crossmember sub-assembly.
| 14. DISCONNECT CONNECTOR |
![]() |
Tilt down the transmission.
Disconnect the park/neutral position switch connector(a).
Disconnect the transmission wire connector(b).
Disconnect the speed sensor NT connector(c).
![]() |
Remove the bolt and wire harness from the transmission.
![]() |
Disconnect the speed sensor SP2 connector.
| 15. REMOVE STARTER ASSEMBLY |
| 16. REMOVE MANIFOLD STAY |
| 17. REMOVE NO.2 MANIFOLD STAY |
| 18. REMOVE NO.1 REAR ENGINE MOUNTING INSULATOR |
![]() |
Remove the 4 bolts 8 and No. 1 rear engine mounting insulator.
| 19. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Remove the torque converter housing side cover from the engine.
Turn the crankshaft to gain access to each bolt.
Hold the crankshaft pulley nut with a wrench and remove the 6 bolts.
![]() |
Remove the 9 bolts.
Separate and remove the automatic transmission assembly.
| 20. REMOVE NO.1 TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and No.1 transmission control cable bracket from the transmission assembly.
| 21. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY |
![]() |
Put matchmarks on the transmission case and torque converter clutch assembly.
Remove the torque converter assembly from the automatic transmission assembly.
| 22. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |