Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION ASSEMBLY (for 2UZ-FE)

AUTOMATIC TRANSMISSION ASSEMBLY (for 2UZ-FE) > REMOVAL

for Preparation Click here



1. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY


2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY


3. DISCONNECT OXYGEN SENSOR

HINT:
(Click here)



4. REMOVE EXHAUST PIPE

HINT:
(Click here)



5. REMOVE PROPELLER SHAFT ASSEMBLY


    C098711E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts and 4 washers.



    C098710E02
  1. Remove the propeller shaft.

  1. Insert SST in the transmission to prevent oil leakage.

    SST
    09325-40010  



6. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug, gasket and drain ATF.

  1. Install a new gasket and drain plug.

    Torque:
    28 N*m{ 285 kgf*cm , 21 ft.*lbf }



7. REMOVE FRONT SUSPENSION MEMBER BRACKET


    F042934
  1. Remove the 4 bolts and front suspension member bracket.



8. REMOVE FRONT SUSPENSION MEMBER BRACKET LH
  1. Remove the 4 bolts and front suspension member bracket LH.



9. DISCONNECT NO.1 OIL COOLER OUTLET TUBE


    Z035556
  1. Remove the 2 bolts and 2 clamps.



    Z035557E01
  1. Using SST, disconnect the No. 1 oil cooler outlet tube.

    SST
    09023-12701  



10. REMOVE NO.1 OIL COOLER INLET TUBE
  1. Using SST, disconnect the No. 1 oil cooler inlet tube.

    SST
    09023-12701  



11. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    F042937
  1. Remove the nut and disconnect the transmission control cable.

  1. Remove the 2 bolts and disconnect the transmission control cable.



12. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY


    Z035558
  1. Support the automatic transmission assembly with a transmission jack.



13. REMOVE NO.3 FRAME CROSSMEMBER SUB-ASSEMBLY


    F042938
  1. Remove the 4 bolts on the No. 3 frame crossmember sub-assembly.

  1. Remove the 4 nuts, 4 bolts and No. 3 frame crossmember sub-assembly.



14. DISCONNECT CONNECTOR


    Z035559
  1. Tilt down the transmission.

    NOTICE:
    Take care so that the cooling fan does not come in contact with the fan shroud.

  1. Disconnect the park/neutral position switch connector.

  1. Disconnect the transmission wire connector.

  1. Disconnect the 2 speed sensor connectors.



15. DISCONNECT WIRE HARNESS


16. REMOVE FLYWHEEL HOUSING UNDER COVER


    F042939
  1. Remove the 2 bolts and flywheel housing under cover.



17. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY


    F042940
  1. Turn the crankshaft to gain access to each bolt.

  1. Hold the crankshaft pulley nut with a wrench and remove the 6 bolts.



    Q003099
  1. Remove the 10 bolts.

  1. Separate and remove the automatic transmission.



18. REMOVE NO.1 REAR ENGINE MOUNTING INSULATOR


    F042941
  1. Remove the 4 bolts and engine mounting insulator rear from the automatic transmission.



19. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY


20. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

HINT:
(Click here)

SST
09350-32014