WATER PUMP > INSTALLATION |
| 1. INSTALL WATER PUMP ASSEMBLY |
![]() |
Install a new O-ring to the water bypass pipe end.
Apply soapy water to the O-ring.
Connect the water pump to the water bypass pipe end.
Install the water pump and new gasket with the 5 bolts, 2 stud bolts and nut. Uniformly tighten the bolts, stud bolts and nut in several passes.
| 2. INSTALL WATER INLET HOUSING |
Remove any old packing (FIPG) material and be careful not to drop any oil on the contact surfaces of the water inlet housing and water pump.
Using a razor blade and gasket scraper, remove all the old packing (FIPG) material from the gasket surfaces and sealing groove.
Thoroughly clean all components to remove all the loose material.
Using a non-residue solvent, clean both sealing surfaces.
![]() |
Apply seal packing to the sealing groove of water inlet housing as shown in the illustration.
Cut the opening of a nozzle for seal packing to a diameter of 2 to 3 mm (0.08 to 0.12 in.), and install it.
Parts must be assembled within 5 minutes of application. Otherwise the material must be removed and reapplied.
Immediately remove the nozzle from the tube and reinstall cap.
Install a new O-ring to the water inlet housing.
Apply soapy water to the O-ring.
Attach the water inlet housing end to the front water bypass joint hole.
Install the water inlet and housing assembly with the 2 bolts. Alternately tighten the bolts.
| 3. INSTALL TIMING BELT |
Install timing belt (Click here).