Home › ENGINE ยท 2UZ-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE TIMING BELT
  1. Remove the timing belt (Click here).



2. REMOVE WATER INLET HOUSING


    A074954
  1. Disconnect the water bypass hose from the water inlet housing.

  1. Remove the 2 bolts holding the water inlet housing to the water pump.

  1. Disconnect the water inlet housing from the front water bypass joint, and remove the water inlet housing w/ water inlet.



3. REMOVE WATER PUMP ASSEMBLY


    B004461
  1. Remove the 5 bolts, 2 stud bolts, nut, water pump and gasket.

  1. Remove the O-ring from the water bypass pipe.