STARTER > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. DRAIN ENGINE COOLANT |
Remove the radiator cap.
![]() |
Remove the service hole cover from the engine under cover No. 1.
Install a vinyl hose onto the drain on the radiator side.
Fix the vinyl hose with tape.
![]() |
Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.
Drain the coolant from the reservoir tank.
Tighten the 3 drain plugs.
Remove the vinyl hose from the radiator.
| 3. DISCONNECT BATTERY NEGATIVE TERMINAL |
Disconnect the battery negative terminal.
| 4. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY |
Remove the 2 nuts and throttle body cover sub-assembly.
| 5. REMOVE AIR CLEANER HOSE ASSEMBLY |
Disconnect the vacuum hoses (for the P/S idle-up and fuel pressure regulator) and ventilation hose.
Remove the air cleaner hose assembly.
| 6. DISCONNECT FUEL HOSE |
![]() |
Remove the pulsation damper and 2 gaskets.
Disconnect the No. 1 fuel hose.
| 7. DISCONNECT NO. 2 FUEL HOSE |
![]() |
Observe the following precautions when disconnecting the fuel tube connector:
Remove the No. 2 fuel pipe clamp.
Check if there is any dirt on the pipe and around the connector before disconnecting them. Clean the dirt away if necessary.
![]() |
Disconnect the connector from the hose while pinching part A with fingers as shown in the illustration.
![]() |
When the connector and the pipe are stuck, pinch the fuel pipe with fingers and push the fuel tube connector to the fuel pipe by pressing the release buttons, then pull the connector out from the pipe. Do not use any tool at this time.
Check if there is any dirt or other foreign objects on the seal surface of the disconnected pipe and clean it away.
![]() |
Do not damage the disconnected pipe and connector, and prevent intrusion of foreign objects by covering them with a plastic bag.
| 8. DISCONNECT FUEL VAPOR FEED HOSE ASSEMBLY |
Disconnect the fuel vapor feed hose assembly.
| 9. SEPARATE ENGINE WIRE |
Disconnect the 8 fuel injector connectors.
Disconnect the throttle position sensor connector.
Disconnect the water temperature sensor connector.
Remove the 3 bolts and separate the engine wire harness.
| 10. DISCONNECT NO. 7 WATER BY-PASS HOSE |
Disconnect the No. 7 water by-pass hose.
| 11. DISCONNECT WATER BY-PASS HOSE |
Disconnect the water by-pass hose.
| 12. REMOVE INTAKE MANIFOLD ASSEMBLY |
Remove the 6 bolts and 4 nuts.
Remove the intake manifold and 2 gaskets.
| 13. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY |
Separate the No. 2 engine wire.
Remove the nut and water by-pass pipe sub-assembly.
| 14. REMOVE REAR WATER BY-PASS JOINT RH |
Remove the 4 nuts, water by-pass joint and 2 gaskets.
| 15. REMOVE AIR PUMP ASSEMBLY |
![]() |
Disconnect the No.2 air hose from the air switching valve.
Disconnect the air switching valve connector.
Disconnect the pressure sensor connector for the air injection system.
Remove the 4 bolts and air pump with bracket assembly.
| 16. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the starter connector.
Remove the nut and disconnect the starter cable.
Remove the bolt and disconnect the engine wire protector.
Remove the 2 bolts and starter.