Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SUSPENSION UPPER ARM BUSH LH


    G020156E02
  1. Using SST and a press, install a new front suspension upper arm bush LH (front side).

    SST
    09710-26010   (09710-05061)

  1. Install the rear side by the same procedures with the front side.



2. TEMPORARILY TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH


    G020153
  1. Install the front suspension upper arm assembly, and temporarily tighten bolt, the 2 washers and the nut.



    G020152
  1. Install the bracket with the bolt.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



    G020157
  1. Install a new nut and a new clip.

    Torque:
    110 N*m{ 1,120 kgf*cm , 81 ft.*lbf }



3. CONNECT SKID CONTROL SENSOR WIRE


    C099168
  1. Install the connect skid control sensor wire with the 2 bolts.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



4. INSTALL FRONT DISC WHEEL

Torque:
112 N*m{ 1,140 kgf*cm , 83 ft.*lbf }



5. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



6. FULLY TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH


    G020158
  1. Fully tighten the nut.

    Torque:
    115 N*m{ 1,170 kgf*cm , 85 ft.*lbf }



7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
(Click here)