Home › SUSPENSION & AXLE › SUSPENSION › REAR UPPER CONTROL ARM

REAR UPPER CONTROL ARM > INSTALLATION

for Preparation Click here



1. INSTALL UPPER CONTROL ARM ASSEMBLY


    D028458E01
  1. Install the upper control arm assembly, temporarily tighten the nut, washer and bolt.

    HINT:
    In the case of the air suspensions, install them by referring to the illustration.



    D028137
  1. Install the rear axle housing, temporarily tighten the nut, washer and bolt.



2. CONNECT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY REAR (w/ Air Suspension)

HINT:
(Click here)



3. INSTALL REAR WHEEL


4. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



5. FULLY TIGHTEN UPPER CONTROL ARM ASSEMBLY


    D028140
  1. Fully tighten the 2 nuts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

    HINT:
    While fixing the bolt, turn and install the nut.