Home › SUSPENSION & AXLE › SUSPENSION › CENTER CONTROL ABSORBER (w/ REAS)

CENTER CONTROL ABSORBER (w/ REAS) > INSTALLATION

for Preparation Click here



1. INSTALL CENTER CONTROL ABSORBER ASSEMBLY LH


    D028265
  1. Install the center control absorber assembly with the 3 nuts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



    D028264
  1. Install the bracket with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



    D028263
  1. Using a spanner to hold the bracket, install the joint.



    D028267E01
  1. Refer to HINT below.

    HINT:
    Tighten the joint so that the gap spacing becomes 1 mm (0.04 in.).

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



    D028266
  1. Using a spanner to hold the center control absorber assembly, install the joint.



    D028267E01
  1. Refer to HINT below.

    HINT:
    Tighten the joint so that the gap spacing becomes 1 mm (0.04 in.).

    Torque:
    Reference:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



2. INSTALL REAR STABILIZER LINK ASSEMBLY

HINT:
(Click here)



3. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 83 ft.*lbf }



4. INSPECT FLUID LEAK

HINT:
(Click here)