Home › SUSPENSION & AXLE › SUSPENSION › CENTER CONTROL ABSORBER (w/ REAS)

CENTER CONTROL ABSORBER (w/ REAS) > REMOVAL

for Preparation Click here


NOTICE:
Be sure to read PRECAUTIONS before performing this procedure (Click here).



1. REMOVE REAR WHEEL


2. REMOVE REAR STABILIZER LINK ASSEMBLY

HINT:
(Click here)



3. REMOVE CENTER CONTROL ABSORBER ASSEMBLY LH


    D028263
  1. Using a spanner to hold the bracket, remove the joint.

    NOTICE:
    Check that all four shock absorbers are fully extended to the normal suspension rebound point.



    D028264
  1. Remove the bolt and disconnect the bracket.



    D028266
  1. Using a spanner to hold the center control absorber assembly, remove the joint.

    NOTICE:
    1. Do not loosen the flare nut.
    2. Do not deform or damage the tubes.



    D028265
  1. Remove the 3 nuts and the center control absorber assembly.

    NOTICE:
    1. Do not deform or damage the tubes.
    2. Be sure to hold the body part to carry the center control absorber assembly.