Home › Vehicle Exterior › BODY WELD POINT › REAR FLOOR REAR CROSS OUTER PANEL
BM1440E _01 Vehicle Exterior _056782 BODY WELD POINT _0276950 REAR FLOOR REAR CROSS OUTER PANEL F

BODY WELD POINT  REAR FLOOR REAR CROSS OUTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K122679

REMOVAL / INSTALLATION


Symbol Meaning
K108819

Remove Weld Points
K108820

Remove Weld Points
K108827

Cut and Join Location
K108822

Spot Weld
K108824

Plug Weld
K108825

Plug Weld
K108831

Butt Weld

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

*a is only for installation.

4.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)

5.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K122744C01
6.583,8.458 6.896,8.615 0.313,0.156 10 false *b 2.24,5.615 2.552,5.813 0.313,0.198 10 false *a 4.521,5.604 4.833,5.802 0.313,0.198 10 false *a 2.219,3.063 2.865,3.406 0.646,0.344 10 false 225 (8.86) 4.323,3.094 4.969,3.438 0.646,0.344 10 false 245 (9.65)
*b mm (in.) - -