Home › Vehicle Exterior › BODY WELD POINT › REAR FLOOR PAN
BM1440E _01 Vehicle Exterior _056782 BODY WELD POINT _0276952 REAR FLOOR PAN F

BODY WELD POINT  REAR FLOOR PAN  ASSEMBLY REPLACEMENT  


K122682

With the rear floor rear cross outer panel and rear floor side panel removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points

REMOVAL POINT
1.

Remove the rear floor side center panel at the same time.


K122750C01
4.875,1.656 5.74,0.75 false 0.573,4.719 0.885,4.875 0.313,0.156 10 false *A 4.073,4.656 4.385,4.813 0.313,0.156 10 false *B 5.792,0.573 6.094,0.792 0.302,0.219 10 false *1
*A LH Side *B RH Side
*1 Rear Floor Side Center Panel - -



INSTALLATION


Symbol Meaning
K108821

Spot Weld
K108823

Plug Weld
K108825

Plug Weld
K108830

Fillet Weld

INSTALLATION POINT
1.

Before temporarily installing the new parts, weld the rear floor side center panel, rear floor plate bracket and weld bolt with the standard number of welding points.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)

4.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K122751C01
1.531,2.958 3.75,2.083 false 4.771,1.479 4.938,1.021 false 0.5,0.385 0.813,0.542 0.313,0.156 10 false *A 0.594,4.802 0.906,4.958 0.313,0.156 10 false *B 1.344,2.896 1.563,3.146 0.219,0.25 10 false *1 4.885,0.823 5.198,0.979 0.313,0.156 10 false *2 3.531,7.896 3.75,8.146 0.219,0.25 10 false *3
*A Upper Face *B Lower Face
*1 Rear Floor Plate Bracket *2 Rear Floor Side Center Panel
*3 Weld Bolt - -


K122752C01
0.594,4.99 0.906,5.146 0.313,0.156 10 false *A 4.177,4.948 4.49,5.104 0.313,0.156 10 false *B
*A LH Side *B RH Side