Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS
BM1440E _V1 General _056784 INTRODUCTION _0276978 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures Necessary when ECU or Other Parts are Replaced
Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed Note
Throttle body with motor assembly Clear crank time compensation data crank -
·

Automatic transmission assembly (for A750F)

·

Valve body assembly (for A750F)

·

Any of the shift solenoid valve (for A750F)


Reset memory Large shift shock -
·

Automatic transmission assembly (for A750E)

·

Valve body assembly (for A750E)

·

Any of the shift solenoid valve (for A750E)


Reset memory Large shift shock -
·

Master cylinder solenoid

·

Yaw rate and acceleration sensor

·

Steering sensor (Spiral cable sub-assembly)


Calibration Vehicle stability control system -
·

Transponder key ECU

·

ECM

·

Key


Code registration Engine immobiliser system Refer to the Service Bulletin for the registration procedure.
·

Door control receiver assembly

·

Key


Code registration Wireless door lock control system -
·

Front power window regulator motor LH

·

Front power window regulator motor RH

·

Rear power window regulator motor LH

·

Rear power window regulator motor RH

·

Back power window regulator motor


Motor initialization Power window control system -
·

Sliding roof ECU (sliding roof drive gear sub-assembly)

·

Sliding roof glass

·

Sliding roof housing


Sliding roof system initialization Auto operation -