OUTLINE
A compact 12-hole type fuel injector assembly is used to increase atomization of the fuel.
A quick connector is used to connect the fuel pipe with the fuel hose for excellent serviceability.
A fuel delivery pipe sub-assembly made of plastic is used.
| *1 | Fuel Pump Module Assembly | *2 | Fuel Pump |
| *3 | Fuel Filter Assembly | *4 | Fuel Pressure Pulsation Damper Assembly |
| *5 | Fuel Delivery Pipe Sub-assembly | *6 | Fuel Injector Assembly |
| *7 | Fuel Pressure Regulator Assembly | *8 | Fuel Tank Assembly |
| *9 | Charcoal Canister Assembly | - | - |
| *1 | Fuel Pump Module Assembly | *2 | Fuel Filter Assembly |
| *3 | Fuel Pump | *4 | Fuel Pressure Pulsation Damper Assembly |
| *5 | Fuel Delivery Pipe Sub-assembly | *6 | Fuel Injector Assembly |
| *7 | Fuel Pressure Regulator Assembly | *8 | Fuel Tank Assembly |
| *9 | Charcoal Canister Assembly | - | - |
A compact fuel pump in which a fuel filter assembly is integrated in the fuel pump module assembly is used*.
*: Models with Onboard Refueling Vapor Recovery (ORVR) Function
A fuel cut control is used to stop the fuel pump if the SRS airbag is deployed in a frontal, side or rear side collision.
Fuel pressure is set to 324 kPa (3.3 kgf/cm2, 46.9 psi) to improve startability with E20 fuel.
E20 fuel is gasoline blended with 20% ethanol.