Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
NM1440E _55 Steering _056100 POWER ASSIST SYSTEMS _0273721 POWER STEERING SYSTEM UN GENERAL/CONTROL/DETAILS F

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

A rack and pinion type steering gear with a hydraulic power steering assist is used.


b.

A Variable Flow Control (VFC) power steering is used.



SPECIFICATION


Power Steering System
Steering Gear Type Rack and Pinion
Power Steering Type Hydraulic
Gear Ratio (Overall) 15.7
Fluid Type ATF Type DEXRON II or III

Steering Gear Assembly
No. of Turns Lock to Lock 3.00
Rack Stroke 158.0 mm (6.2 in.)

Vane Pump Assembly
Engine Type 1GR-FE
Theoretical Discharge Rate (@ 1000 r/min) 11.0 l/min
Relief Pressure 8.3 MPa (84.6 kgf/cm2, 1203.8 psi)
Drive Type Belt


MAIN FEATURES


a.

Variable Flow Control (VFC) Power Steering

i.

The VFC power steering is provided with a solenoid valve, which is controlled by the power steering ECU, in the vane pump.


ii.

The solenoid valve controls the discharge flow rate of the power steering fluid in accordance with the operating conditions of the steering wheel, vehicle speed, engine speed and transfer drive mode. Thus, it reduces the load on the engine applied by the actuation of the vane pump, and improves fuel economy.