Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2013.08
NM1440E _57 Power Source / Network _056104 NETWORKING _0273728 CAN COMMUNICATION SYSTEM UN GENERAL/CONTROL/DETAILS F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

The Controller Area Network (CAN) uses 2 different CAN buses: CAN V bus for high-speed communication (500 kbps) and CAN MS bus for medium-speed communication (250 kbps).


b.

The CAN has 2 terminating resistors which are necessary for accurate judgment of communication on the main bus.


c.

The terminating resistors for each bus are located as shown in the following table.

Bus Terminating Resistor Location
CAN V Bus
·

ECM

·

Combination Meter Assembly


CAN MS Bus*1
·

Main Body ECU (Multiplex Network Body ECU)

·

Combination Meter Assembly



*1: Models with seat position memory



d.

The main body ECU (multiplex network body ECU) has a gateway function and is used to transmit data between the CAN MS bus and the CAN V bus.