Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
NM1440E _57 Power Source / Network _056104 NETWORKING _0273728 CAN COMMUNICATION SYSTEM UN GENERAL/CONTROL/DETAILS F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


DIAGNOSIS


a.

If a malfunction occurs on the CAN communication bus, ECUs that are connected to the CAN communication bus store the Diagnostic Trouble Code (DTC) in memory.


b.

The 5-digit DTCs can be read after connecting Techstream to DLC3.


c.

DLC3 is equipped with a CAN-H and a CAN-L terminal on the CAN No. 1 bus to allow CAN diagnosis. It is possible to determine if there is an open or short in the main wires of the each CAN bus by measuring the resistance value between these terminals. For details, refer to the Repair Manual.