Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
NM1440E _58 Vehicle Interior _056111 HEATING / AIR CONDITIONING _0273740 AIR CONDITIONING SYSTEM UN GENERAL/CONTROL/DETAILS F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

2 types of air conditioning system are used, manual and automatic.


b.

The automatic air conditioning system uses left and right independent temperature control to enhance comfort.



SPECIFICATION


a.

Performance

Heater Heater Output W 5750
Air Flow Volume m3/h 350
Power Consumption W 250
Cooler Cooling Capacity W 5770
Air Flow Volume m3/h 540
Power Consumption W 300


b.

Ventilation and Heater Core

Heater Radiator Unit Sub-assembly Type Straight Flow Aluminum (SFA) -II
Size W x H x L mm (in.) 243.2 x 140 x 27
(9.6 x 5.5 x 1.1)
Fin Pitch mm (in.) 1.5 (0.06)
Blower Motor Motor Type K70-BMM
Fan Type Semi Sirocco
Fan Size (Dia. x H) mm (in.) 165 x 70 (6.5 x 2.8)


c.

Air Conditioning

Cooler Condenser Assembly Type Multi-Flow (MF)-IV
Size W x H x L mm (in.) 600 x 491.8 x 16
(23.6 x 19.4 x 0.6)
Fin Pitch mm (in.) 3.15 (0.12)
Air Conditioning Compressor (Compressor and Magnetic Clutch) Type 10S17C
Pulley Steel with Magnetic Clutch
Oil Volume cc 120 to 135
Refrigerant Type HFC 134a
Charge Volume g 520 to 580
Evaporator Type Revolutionary super-slim Structure (RS)
Size W x H x L mm (in.) 252.9 x 231 x 38
(10.0 x 9.1 x 1.5)
Fin Pitch mm (in.) 2.6 (0.10)



MAIN FEATURES


a.

The manual and automatic air conditioning system has the following features:

Features Outline Air Conditioning Type
Manual Automatic
High Performance Neural network control is used so passengers can finely control the air conditioning for maximum comfort. - ○
Air outlet from console for the rear seat is installed to blow air and ensure excellent air conditioning performance. ○ ○
A pollen-removal type clean air filter, which has a pollen-removal effect, is used. ○ ○
The blower control has 7 levels to allow precise control. ○ -
The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control. - ○
The left and right independent temperature controls ensure further comfort. - ○
A MAX A/C setting is provided on the temperature control switch to improve cooling efficiency. ○ -
Lightweight A Bus connector with a built-in IC is used in a lightweight wire harness design to allow a reduced number of wires. ○ ○
The use of this connector means that pulse pattern type servo motors are used. ○ ○
Compact A blower motor with a built-in blower motor controller is used in a compact construction. ○ ○
Others The following parts are used to ensure high cooling performance while realizing a compact and lightweight construction.
·

Semi-center location air conditioning unit

·

Revolutionary super-slim Structure (RS) evaporator

·

Straight Flow Aluminum (SFA)-II heater radiator unit sub-assembly

·

Multi-Flow (MF)-IV sub-cool cooler condenser assembly


○ ○