FUNCTION
Impact Absorbing Structure for Side Collision
Using double-piled reinforcements and brackets reinforces the sun roof housing assembly, which increases safety.
| *1 | Sun Roof Housing Assembly | *2 | Reinforcement |
| *3 | Bracket | - | - |
| *a | A-A Cross Section | - | - |
A head impact protection structure is used. With this type of construction, if the occupant's head hits against the roof side rail or pillar due to a collision, the inner panels of the roof side rail and pillar collapse to help reduce the impact.
|
Head Impact Protection Structure | - | - |
Energy absorbing pads are used for the front and rear door trims and front door to help protect passengers from side collisions.
Crushable structures are used for the front and rear door trim arm rests, on the areas where passengers may come into contact in the case of an accident, reducing the impact on the passengers.
| *1 | Front Door | *2 | Front Door Trim |
| *3 | Rear Door Trim | - | - |
|
Energy Absorbing Pad |
|
Crushable Structure |
Lessening Pedestrian Injury
A longitudinal ribbed structure is adopted for the inner hood to cushion impact.
| *1 | Hood Panel | - | - |
| *a | Longitudinal Ribbed Structure | - | - |
An impact absorbing bracket is used for the mounting portion of the front fender panel to absorb impact energy to the head of the pedestrian in a collision, thus dampening the impact to the head.
| *1 | Impact Absorbing Bracket | - | - |
The cowl area has an open structure. In the event of a collision with a pedestrian, this structure helps lessen the impact inflicted by the cowl to the head of the pedestrian.
| *1 | Hood Panel | *2 | Windshield Glass |
| *3 | Cowl Top Ventilator Louver | *4 | Cowl Top Panel |
| *a | A-A Cross Section | *b | Open Section Structure |
Aerodynamics
The Front Spoiler, Rear Spats, Under Cover and Rear Spoiler are adopted to achieve the excellent aerodynamic performance.
| *1 | Front Spoiler | *2 | Rear Spats |
| *3 | Under Cover | *4 | Rear Spoiler |
CONSTRUCTION
High-strength Steel Sheet
High-strength steel sheet is used in order to achieve excellent body rigidity and a lightweight body.
|
High-Strength Steel Sheet | - | - |
Anti-corrosion Steel Sheet
Anti-corrosion steel sheet is used as in the following illustration:
| *A | Models with Sliding Roof | - | - |
|
Anti-corrosion Steel Sheet | - | - |
Under Coat
Acrylic acid resin is applied to the under side of the body, inside the wheel housing and other parts that are susceptible to stone chipping damage, thus improving the rust-resistant performance of these areas.
| *a | Under Floor | *b | Rear Wheel House |
|
Edge Seal |
|
Acrylic Acid Resin Coating Area |
|
Acrylic Acid Resin Coating Area (Thick Coating) | - | - |
Anti-chipping Application
To protect the paint from chipping, anti-chipping paint is applied to the door panels and the hood panel.
|
Soft-chip Primer Area |
|
PVC-chip Primer Area |
Low Vibration and Low Noise Body
The layout of the sound-absorbing material is optimized to reduce noise and vibration.
|
Sound-absorbing Material | - | - |
To reduce the amount of road noise, engine noise, and droning sound that enters the cabin, the floor panel is coated with a floor silencer.
| *A | Two-row Seat Models | *B | Three-row Seat Models |
|
Floor Silencer | - | - |
To achieve a quiet cabin, sound-absorbing material is optimally allocated across a wide area including the floor carpet, ceiling, inner dash silencer and door trim.
|
Sound-absorbing Material | - | - |