Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273865 ACCELERATOR PEDAL A

1GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid physical shocks to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

This accelerator pedal does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

Install the accelerator pedal sensor with the 2 nuts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


b.

Connect the accelerator pedal position sensor connector.