Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273873 HEATED OXYGEN SENSOR A

1GR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.
A158663

Temporarily install the sensor to the exhaust pipe by hand.


b.
A223688E06
2.896,0.875 2.656,0.875 2.656,0.875 2.375,1.042 true 0.823,0.792 1,0.958 0.177,0.167 10 true *a 2.969,0.771 3.313,1.031 0.344,0.26 9 true SST

Using SST, tighten the sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*a Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




c.

Connect the sensor connector.


Hide 89465A 2.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

a.
A158663

Temporarily install the sensor to the exhaust pipe by hand.


b.
A223690E06
2.594,0.344 2.417,0.344 2.417,0.344 1.99,0.688 true 0.802,0.313 1,0.51 0.198,0.198 10 true *a 2.646,0.271 3,0.469 0.354,0.198 10 false SST

Using SST, tighten the sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*a Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.