89465
1.INSPECT HEATED OXYGEN SENSOR
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (HT1B) - 2 (+B) | 20°C (68°F) | 11 to 16 Ω |
| 1 (HT1B) - 4 (E2) | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (HT2B) - 2 (+B) | 20°C (68°F) | 11 to 16 Ω |
| 1 (HT2B) - 4 (E2) | Always | 10 kΩ or higher |
| *A | for Bank 1 |
| *B | for Bank 2 |
| *a | Component without harness connected
(Heated Oxygen Sensor) |
If the result is not as specified, replace the heated oxygen sensor.