Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273874 POWER STEERING OIL PRESSURE SWITCH A

1GR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 89438A 1.INSTALL POWER STEERING OIL PRESSURE SWITCH

a.

Install a new O-ring to the oil pressure switch.


b.

Apply a light coat of engine oil to the O-ring of the oil pressure switch.


c.

Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque:
21 N*m (210 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (surface which contacts the pressure feed tube).

·

Be careful not to damage the O-ring when installing the power steering oil pressure switch




d.

Connect the oil pressure switch connector.


Hide 2.ADD POWER STEERING FLUID

Hide 3.INSPECT FOR POWER STEERING FLUID LEAK