Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273874 POWER STEERING OIL PRESSURE SWITCH G

1GR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89438B 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Check the oil pressure switch.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Power Steering Switch.


v.

Start the engine.


vi.

Read the value displayed on the intelligent tester.

OK:
Condition Specified Condition
Power steering operating ON
Power steering not operating OFF


If the result is not as specified, check the wire harness and connector. If the wire harness and connector are normal, replace the power steering oil pressure switch.